The width of landings must be as wide as the stairways that they serve.There must be a floor or landing at the top and bottom of each stairway.Solid risers are required for IBC stairs except for means of egress stairways as long as the opening between treads does not allow a 1/2 inch diameter sphere to pass through. The difference between the largest and smallest tread depth or riser height cannot be more than 3/8 inch. IBC stairs must have the same riser and tread dimensions throughout the stairway. If the stairs have nosings, you measure from the leading edge of the nosing to the edge of the next step’s nosing. The step height, also known as the riser height, must be no less than 4 inches and no greater than 7 inches. Riser Height and Tread Depth (IBC 1011.5) The clearance must continue past the last step for at least one stair tread depth. Stairways are required to have a headroom clearance of 80 inches from the edge of each stair nosing measured vertically up to the ceiling. Read More: Differences in IBC and OSHA Requirements Headroom (IBC 1011.3) You must calculate the IBC stair width for multi-story stairways versus single-story stairways. However, the very minimum width between handrails is 44 inches. In short, the width is calculated by multiplying the occupant load served by such stairs by a factor of 0.3 inch per occupant. The number of occupants on each floor will determine the required width of the stairs.
#Interior stair rail code code
The International Building Code (IBC) has many requirements for stairways, and you must also meet the required number of means of egress and areas of refuge for wheelchairs.
0 kommentar(er)
